Rodrigue knives

[Bear_Blade]

Gentlemen! (And of course ladies! )

This is a new steel I am trying, it is a high carbon steel, at HRC 64.5, Transitional grind. Convex lower, and slight hollow upper blade.

It has a G10 ferrule, stainless and mammoth tooth spacer

African black wood handle, wood from Mark at Burl Source. This stuff polishes up like glass!

Keep in mind, this is pre sharpening and pre glue up.

Thanks for looking, and comments welcome!

IMG_4267.jpgIMG_4272.jpgIMG_4268.jpgIMG_4271.jpg
IMG_4269.jpgIMG_4270.jpgIMG_4264.jpgIMG_4265.jpg

[RobinW]

I like the knife in hte first post...

[UA8]

Gentlemen! (And of course ladies! )

This is a new steel I am trying, it is a high carbon steel, at HRC 64.5, Transitional grind. Convex lower, and slight hollow upper blade.

It has a G10 ferrule, stainless and mammoth tooth spacer

African black wood handle, wood from Mark at Burl Source. This stuff polishes up like glass!

Keep in mind, this is pre sharpening and pre glue up.

Thanks for looking, and comments welcome!

Attachment 2876Attachment 2877Attachment 2878Attachment 2879
Attachment 2880Attachment 2881Attachment 2882Attachment 2883

Holy crap that is an awesome knife, Pierre. Once I'm making some money and out from under my debt I'm looking you up!

[rhinoknives1]

HHmmm? Looks good Pierre. Nice work!
How did you grind your hollow before Convexing? A large diameter wheel?

Laurence

www.westsidesharpening.com/